Welcome Guest. Sign in or Signup

5 Answers

Why we requierd to track HOBBS AND TACH?

Asked by: 9838 views General Aviation

To track one of them is not enough?
When the school charging as they always go by the Habbs which is more than the Tach

Ace Any FAA Written Test!
Actual FAA Questions / Free Lifetime Updates
The best explanations in the business
Fast, efficient study.
Pass Your Checkride With Confidence!
FAA Practical Test prep that reflects actual checkrides.
Any checkride: Airplane, Helicopter, Glider, etc.
Written and maintained by actual pilot examiners and master CFIs.
The World's Most Trusted eLogbook
Be Organized, Current, Professional, and Safe.
Highly customizable - for student pilots through pros.
Free Transition Service for users of other eLogs.
Our sincere thanks to pilots such as yourself who support AskACFI while helping themselves by using the awesome PC, Mac, iPhone/iPad, and Android aviation apps of our sponsors.

5 Answers



  1. Lucas on Aug 26, 2012

    If you Idle the engine for 1 hour the tach will show close to 20 minutes of time so you would only pay for 20 minutes instead of 1 hour. Vice versa if you keep the RPM at maximum you would probably end up paying for 1.5 hours.
    The hobbs on the other hand is an actual clock and that should be precise.
    In general, most schools that have an airplane where the hobbs is not present, will multiply the tach * 1.3 to try an get an accurate timing to charge the student.

    Lucas
    http://passfaaexams.com/

    -1 Votes Thumb up 1 Votes Thumb down 2 Votes



  2. Wes Beard on Aug 26, 2012

    For more information…

    The tach time measures the number of revolutions the propeller makes. Typically, the tach time is set so that it will read accurately for one hour when at a cruise setting of 2400-2500 RPM. Each manufacturer sets it differently. In essence, if you measured the accuracy of the tach time against a clock, it will be most accurate when the RPMs are somewhere in that range.

    The tach time slows down with a slower RPM and speeds up with a faster RPM.

    I generally agree with the tach time conversion of 1.3 hours for a training aircraft. Be advised that during cross country flights that conversion is too great. It may be closer to a 1.1 factor.

    The other issue is with a constant speed propeller (CSP). Since tach time measures RPM, a CSP will remain within that envelope much longer and the conversion factor is going to be less. I almost lost a good friend who I fly with due to this issue. I ignorantly relied on the 1.3 factor as our flight time and when we measured against an actual clock I was off by a half hour on some of the cross country flights we did. Lesson learned.

    0 Votes Thumb up 1 Votes Thumb down 1 Votes



  3. Alex Clark on Aug 26, 2012

    Hobbs = Billing and logging of time. Mostly billing…

    Tach = Engine maintenance, oil changes, time to 100 hour inspection and so on.

    +12 Votes Thumb up 12 Votes Thumb down 0 Votes



  4. David A Hatcher on Sep 03, 2012

    When you rent an aircraft you are paying for “flight time”. From 14 CFR Part 1; Definitions and Abbreviations Flight time means: (1) Pilot time that commences when an aircraft moves under its own power for the purpose of flight and ends when the aircraft comes to rest after landing
    For maintenance purposes flight time beginning when all the stress for flight is placed on the airframe and engine.
    So taxi time (for the purpose of flight) is considered flight time (you’re paying for!) while that time would not be (fully) considered for overhaul, oil changes, inspections etc.
    By “logging both” as a rental pilot you are just helping a little administrative work for the flight school/FBO

    +2 Votes Thumb up 2 Votes Thumb down 0 Votes



  5. Sam Dawson on Nov 05, 2012

    Just to add to what David wrote. Though Hobbs time is often used in logging flight time it is not the legal definition of flight time and may not be accurate. I have seen GA airplane Hobbs meters use oil pressure, indicated airspeed, airflow, vibration, and electrical power to record “flight time”. As David pointed out none of these are the definition of flight time. As a student you may be getting robbed of valid a valuable flight time if you are not using the legal definition; as a commercial pilot you may be in violation of the regulations by not using the FAA definition of flight time.

    0 Votes Thumb up 0 Votes Thumb down 0 Votes


Answer Question

Our sincere thanks to all who contribute constructively to this forum in answering flight training questions. If you are a flight instructor or represent a flight school / FBO offering flight instruction, you are welcome to include links to your site and related contact information as it pertains to offering local flight instruction in a specific geographic area. Additionally, direct links to FAA and related official government sources of information are welcome. However we thank you for your understanding that links to other sites or text that may be construed as explicit or implicit advertising of other business, sites, or goods/services are not permitted even if such links nominally are relevant to the question asked.