Welcome Guest. Sign in or Signup

2 Answers

GPS Approach minimum

Asked by: 7449 views , ,
Airspace, Instrument Rating

Washington Warren Filed (OCW) RNAV (GPS) RWY 23

LPV DA 436

LNAV MDA 420

Why is the LNAV MDA (which requires only a IFR approach cercified GPS) lower than the LPV DA (which requires a WAAS receiver).

 

2 Answers



  1. Kent Shook on Apr 12, 2011

    Paging John Collins… Paging John Collins…
     
    Until he shows up here, I’ll point you to this excellent post he made over at pilotsofamerica.com about a similar issue: http://www.pilotsofamerica.com/forum/showpost.php?p=652684&postcount=3
     

    0 Votes Thumb up 0 Votes Thumb down 0 Votes



  2. John D. Collins on Apr 12, 2011

    Very good question.  If you look at the approach chart, you can observe several facts.  There is a 168 foot obstacle on short final.  The profile view does not show a gray feather extending to the threshold, which indicates that the visual segment is not clear on a 34-1 slope ratio, 34-1 is required to obtain the lowest LPV minimums.  Also, the profile view does not have a VDP (Visual Descent Point) depicted on the final segment.  A VDP is depicted for the LNAV minimums anytime the visual segment is clear on a 20-1 slope ratio.  Since the VDP is not on the chart, one can conclude the final is not clear on the 20-1 slope.  All of these facts, put together, indicate that the visual segment is obstacle challenged.

     

    For the LNAV MDA, the minimums are determined to be 250 feet above the controlling obstacle.  So the MDA in this case will be 168+250= 418 feet MSL.  This is rounded up to the nearest 20 foot increment, or 420 feet MSL.

     

    The LPV minimums are more complicated, in that obstacles are evaluated along a sloping Obstacle Clearance Surface (OCS) that is offset from the runway threshold.  Any obstacle that penetrates the OCS, requires an adjustment in one of the LPV parameters, the glidepath angle, the threshold crossing height. the DA, or a combination of the three.  When the obstacle is close to the runway as is true in this case, it is imperative that the obstacle be in the visual segment (below the DA) with sufficient clearance for the pilot to see and avoid it after breaking out. To accomplish this, the height of the obstacle is projected back along the approach path until it intercepts the OCS.  The DA is then positioned over this point.  The further you have to project the obstacle to match the OCS, the higher the DA.  In this case, the result is what you see with the DA at 436 feet MSL.  Note also that because the DA is further from the threshold, the visibility requirements are increased as well to 1.5 miles verses the 1 mile requirement for the LNAV.  Remember the LNAV allows the pilot to motor up to the threshold, and therefore requires a lower visibility whereas the LPV has a DA and the pilot must see the runway from that point.

     

    +5 Votes Thumb up 5 Votes Thumb down 0 Votes


Answer Question

Our sincere thanks to all who contribute constructively to this forum in answering flight training questions. If you are a flight instructor or represent a flight school / FBO offering flight instruction, you are welcome to include links to your site and related contact information as it pertains to offering local flight instruction in a specific geographic area. Additionally, direct links to FAA and related official government sources of information are welcome. However we thank you for your understanding that links to other sites or text that may be construed as explicit or implicit advertising of other business, sites, or goods/services are not permitted even if such links nominally are relevant to the question asked.