Welcome Guest. Sign in or Signup

1 Answers

Magneto Grounding check & Engine idle check during run up.

Asked by: 3778 views Aircraft Systems, Commercial Pilot, Flight Instructor, General Aviation, Private Pilot, Student Pilot

Hi everyone,

In our school, in the shut down checklist we instantaneously turn the key from both to off and back to both to check 'grounding' of the magneto. I am not sure why we do this but all I know is that there is a p-lead wire on primary coil that runs back to cockpit.

Secondly, after the run-up check, we pull the throttle  all the way idle and make sure RPM does not drop below 675RPM, do you know where does this number come from and why?

Lastly, how does high manifold pressure on engine can cause detonation?

 

Steve

Ace Any FAA Written Test!
Actual FAA Questions / Free Lifetime Updates
The best explanations in the business
Fast, efficient study.
Pass Your Checkride With Confidence!
FAA Practical Test prep that reflects actual checkrides.
Any checkride: Airplane, Helicopter, Glider, etc.
Written and maintained by actual pilot examiners and master CFIs.
The World's Most Trusted eLogbook
Be Organized, Current, Professional, and Safe.
Highly customizable - for student pilots through pros.
Free Transition Service for users of other eLogs.
Our sincere thanks to pilots such as yourself who support AskACFI while helping themselves by using the awesome PC, Mac, iPhone/iPad, and Android aviation apps of our sponsors.

1 Answers



  1. Kris Kortokrax on Jun 03, 2016

    If you turn the mag switch to OFF and the engine does not die, then you have at least one P lead wire broken or a bad switch. Turning the switch to OFF grounds the magnetos and prevents them from creating a spark.

    The idle check (which should be done with carb heat on because of lower RPM) is to assure you that if you pull the throttle back in flight to simulate an engine failure or to perform a stall, for example, that your engine will not quit.

    Download a copy of the Pilot’s Handbook of Aeronautical Knowledge. Detonation is discussed on page 6-19. High manifold pressure, in and of itself, does not cause detonation, it is high manifold pressure coupled with a low RPM setting on the prop. This has led to the Old Wive’s Tale that one should not run an engine “over square”.

    +1 Votes Thumb up 1 Votes Thumb down 0 Votes


The following terms have been auto-detected the question above and any answers or discussion provided. Click on a term to see its definition from the Dauntless Aviation JargonBuster Glossary.

Answer Question

Our sincere thanks to all who contribute constructively to this forum in answering flight training questions. If you are a flight instructor or represent a flight school / FBO offering flight instruction, you are welcome to include links to your site and related contact information as it pertains to offering local flight instruction in a specific geographic area. Additionally, direct links to FAA and related official government sources of information are welcome. However we thank you for your understanding that links to other sites or text that may be construed as explicit or implicit advertising of other business, sites, or goods/services are not permitted even if such links nominally are relevant to the question asked.