Welcome Guest. Sign in or Signup

4 Answers

Engine compressor stalls

Asked by: 10271 views Aircraft Systems, Commercial Pilot

When do engine compressor stalls usually occur?

Ace Any FAA Written Test!
Actual FAA Questions / Free Lifetime Updates
The best explanations in the business
Fast, efficient study.
Pass Your Checkride With Confidence!
FAA Practical Test prep that reflects actual checkrides.
Any checkride: Airplane, Helicopter, Glider, etc.
Written and maintained by actual pilot examiners and master CFIs.
The World's Most Trusted eLogbook
Be Organized, Current, Professional, and Safe.
Highly customizable - for student pilots through pros.
Free Transition Service for users of other eLogs.
Our sincere thanks to pilots such as yourself who support AskACFI while helping themselves by using the awesome PC, Mac, iPhone/iPad, and Android aviation apps of our sponsors.

4 Answers



  1. Aaron on Nov 18, 2013

    Turbine engine compressors stall when the airflow within them is disrupted. In order to understand this concept, you must first understand how a turbine engine works. It has the four stages hat a typical combustion engine has, but in a turbine engine they occur simultaneously. The air is taken into the engine, where it passes through several compression stages where spinning blades (in an axial flow compressor) or spinning discs with slots (in a centrifugal flow compressor) send the air further into the engine, increasing the pressure as it goes along until it is at a very high pressure just before entering the combustion (hot) section. There it is ignited, and sent out the back past another set of turbines which spin in the wake of the exhaust gasses (much like blowing into a small fan makes it turn) which in turn provide the rotation to the compressor section. It is completely self sustaining because the combustion section is constantly burning, so the flame is always there. So long as here is adequate pressure in the compressor section to keep the reaction moving front to back instead of the other way around. When the air pressure from the compressor section is inadequate to keep the combustion from going out the front, a compressor stall occurs.

    To answer your question, there are several times a compressor stall is likely to occur. It can be the result of damage to the compressor blades themselves, debris (birds, FOD on the runway, etc), or very intense precipitation. Therefore anytime you have the chance that something can disrupt the airflow, a compressor stall is a possibility. Good times for this to occur are during intense thunderstorms, or during takeoff when thrust is at a maximum and debris on the runway can get sucked into the engine.

    +4 Votes Thumb up 4 Votes Thumb down 0 Votes



  2. Aaron on Nov 18, 2013

    Also, I almost forgot: when the angle of attack of an aircraft is either very high or very low, the airflow into the engine can be disrupted. It is much like an airplane wing stalls. The air cannot be efficiently taken into the engine, because it is “blocked” by the cowl. This causes insufficient airflow into the engine, and a compressor stall can occur here. This adds to the likelihood that a compressor stalls will occur during takeoff, because over-rotation of the aircraft can cause the angle of attack to become to great for the air to flow smoothly into the engine.

    +1 Votes Thumb up 1 Votes Thumb down 0 Votes



  3. Sam Dawson on Nov 18, 2013

    I have gotten compressor stalls on two other occasions.
    One was fire fighting- I assume the fire on the ground sucked most of the oxygen necessary for engine combustion causing compressor stall.
    Second was during engine shut down on the ground in extremely hot -great than 120 degrees OAT, probably hotter on the ramp- and humid air (this was the Persian/Arabian Gulf).

    -2 Votes Thumb up 0 Votes Thumb down 2 Votes



  4. Waqas zeb on Dec 15, 2013

    Compressor blades are much like aerofoils. air entering the compressor is always at a particular angle to the blades. This angle is AOA. The airflow entering the compressor is the resultant of compressor rotational velocity vector and incident air vector. Whenever rotational velocity vector would be greater than incident velocity vector the AOA would increase wrt the compressor blade. When it reaches the critical AOA the blade or blades of compressor stall

    +1 Votes Thumb up 1 Votes Thumb down 0 Votes


Answer Question

Our sincere thanks to all who contribute constructively to this forum in answering flight training questions. If you are a flight instructor or represent a flight school / FBO offering flight instruction, you are welcome to include links to your site and related contact information as it pertains to offering local flight instruction in a specific geographic area. Additionally, direct links to FAA and related official government sources of information are welcome. However we thank you for your understanding that links to other sites or text that may be construed as explicit or implicit advertising of other business, sites, or goods/services are not permitted even if such links nominally are relevant to the question asked.